Develop ineo 350 - Page 219

11. Tech. Rep. Mode Field Service Ver. 1.0 Aug. 2005
180
bizhub 200/250/350
Adjustment / Setting
11.11.3 Software SW setting for CS Remote Care
NOTE
• In case you changed bit data by accident, be sure to restore the previous state.
A. Input procedure
1. Select [
Tech. Rep. Mode] → [CS Remote Care] → [Detail Setting], and touch [Software
Switch Setting].
2. Touch [Mode Selection], and input the SW number (two digits) using the 10-Key Pad.
3. Touch [Bit Selection], and select SW bit number using the arrow keys, and input 0 or 1
using the 10-Key Pad.
(For setting by hexadecimal numbers, touch [HEX Selection], and input using the 10-
Key Pad or A to F keys.)
4. Touch [Enter].
NOTE
• About functions of each switch, see to “B. List of software SW for CS Remote
Care.”
B. List of software SW for CS Remote Care
NOTE
• Do not change any bit not described on this table.
SW No. Bit Functions 0 1 Default
SW 01 0 Dial Mode Pulse Tone 1
1 Reservation — — 0
2 Reservation — — 0
3 Reservation — — 0
4 Baud rate *1 *1 0
5*1*10
6*1*10
7*1*11
SW 02 0 Emergency transmission Do not call Call 1
1 Date specified transmission Do not call Call 1
2 Reservation — — 0
3 Reservation — — 0
4 Reservation — — 0
5 Auto call on the IC Life Do not call Call 1
6 Reservation Do not call Call 1
7 Reservation — — 0
SW 03 0 Reservation — — 0
1 Auto call on the toner empty Do not call Call 1
2 Reservation — — 0
3 Reservation Do not call Call 1
4 to 7 Reservation — — 0
SW 04 0 to 7 Reservation — — 0