13. Timing 247
13.2.2 Delay Time
You can create a delay between the cue being triggered and the fade times beginning to
execute by assigning the Delay time:
1. List 1 Open : open the cuelist.
2. Select the cue's Dela y cell and press Set.
3. 5 , Enter : enter the delay time. As with fade times you can assign separate delay
times for the incoming and outgoing parts of the cue, for example 3 / 5 .
Alternatively, you can use the command line, pressing the Time key twice to assign the
delay time:
Cue 2 Time Time 5 Enter
Tip: Note that the Delay time should not be confused with the Wait time; see Cue Wait
Timing.
13.2.3 Paths
Paths determine the way parameter values change during a cue. For example, with the
simplest (linear) path, an intensity parameter travels from its start value to its end value at a
steady rate of change for the duration of the cue. The paths available are shown below.
To Next Page
Loading...
