17. Playback 305
17.1.4 Configuring Physical Master Playback Controls
Once attached to a physical master, cuelists, scenes, and batches can be played back using
the hardware keys located below the physical master's choose key as well as via the
console's main playback keys (located to the right of master 10 on Hog 4 / Full Boar 4,
located to the left master 1 on Road Hog 4, and located to the right of master 5 on HedgeHog
4).
Hog 4 OS uses mappings called "control sets" to define which playback commands are
executed when a hardware key is pressed. Every cuelist, scene, and batch has five
interchangeable master control sets (standard, intensity, playback rate, effect rate, effect
size) and one main control set. This following two sections will cover how to access and
customize these control sets as well as how to use them in playback.
Tip: Holding down the PIG key while pressing any one of a master's playback keys will
release that master regardless of the function assigned to that key.
Master Control Sets
Every cuelist, scene, and batch has five interchangeable master control sets (standard,
intensity, playback rate, effect rate, and effect size) which contain playback command
mappings for the physical master's Go, Halt/Back, Back, Fla sh, and Fader controls. When
a cuelist, scene, or batch is attached to a physical master, the standard control set is used
by default.
To configure the master control sets for a cuelist, scene, or batch already assigned to a
physical master hold the pig key and then press the [choose] key coordinating with physical
master to which the lists/scene/batch is assigned.
To configure the master control sets for a cuelist, scene, or batch not already assigned to a
physical master open the master window using the open syntax (example: [L ist] [ 1 ] [Ope n])
and then press the options button at the top of the master window.
To Next Page
Loading...
