Commands Assignable only to the Flash key
Command Notes Options
None Disables the control
Flash
intensity at
Brings the intensity to a specified level
regardless of the assignment of the fader. To
specifically flash the assignment of the fader
please use "Flash Fader at".
Level: proportion of the programmed
intensity that contents are flashed to.
If programmed levels are 80% and the
flash level is set to 50% the flashed
output intensity will be 40%.
Go On Flash : goes the master when
the Flash key is pressed.
Release on Off: releases the master
when the Flash key is released.
Solo : sends intensity output of all
other physical and virtual masters to
zero while the Flash key is held.
Latching: action of the Flash key is
maintained until it is pressed a second
time.
* Latching the flash key can also be
accomplished even when the latch
option is turned off by pressing the pig
key while the flash key is held, then
releasing the flash key, and then
releasing the pig key.
Flash
Fader at
Flashes fader assignment to level specified in
the options. This is similar to "flash instensity
at" except it flashes the command assigned
to the fader and instead of flashing intensity.
Flash
Fader Full
Flashes the command assigned to the fader
to its highest level.
Flash
Fader Zero
Flashes the command assigned to the fader
to its lowest level.
Flash
Fader
Opposite
Flashes the command assigned to the fader
to either is highest or lowest level depending
on the position of the fader. Its the fader level
is at 50% or higher then flash level is 0%. If
the fader level is below 50% then the flash
level is 100%.
To Next Page
Loading...
