Fuji Electric ALPHA5 Smart - Page 334

CHAPTER 6 KEYPAD
6-22
Monitor Mode
6
(16) DC link voltage (min.) (displayed digits: unsigned three digits)
The DC link voltage (min.) of the servo amplifier at every
two seconds is displayed.
The displaying range is from 0 to 500 V.
"LV" (under-voltage) is detected at 200 V.
(17) VREF input voltage (displayed digits: signed four digits)
The input voltage of the analog input terminal [VREF] is
displayed in 0.01 V. The negative sign indicates a negative
voltage.
(18) TREF input voltage (displayed digits: signed four digits)
The input voltage of the analog input terminal [TREF] is
displayed in 0.01 V. The negative sign indicates a negative
voltage.
on16
300
ESC
SET
(1 sec. or over)
on17
10
.
00
ESC
SET
(1 sec. or over)
10
.
00 -
0.
00
The figure and "-" symbol are displayed alternately.
With a negative four-digit data
on18
10
.
00
ESC
SET
(1 sec. or over)
10
.
00 -
0.
00
The figure and "-" symbol are displayed alternately.
With a negative data