CHAPTER 6 KEYPAD
Monitor Mode 6-23
6
(19) Input signals
The ON/OFF status of sequence input signals supplied to
the servo amplifier is displayed.
The corresponding LED lights up when the input signal is
turned on.
While all the input signals are off, the display shows
“
nonE.
(20) Output signals
The ON/OFF status of sequence output signals issued by
the servo amplifier is displayed.
The corresponding LED lights up when the output signal is
turned on.
While all the output signals are off, the display shows
“
nonE.
on19
SET
(1 sec. or over)
11111111
11111111
CONT 16・・・・・・CONT 9
----
----
SHIFT
11111111
11111111
CONT 24・・・・CONT 17
Blinks
three times.
Blinks
three times.
ESC
ESC
U
L
／
on20
SET
(1 sec. or over)
1 1 1 1 1 1 1 1
11111111
OUT 8・・・・・・OUT 1
OUT16・・・・・・OUT 9
----
----
SHIFT
11111111
11111111
OUT 21・・・・OUT 17
Blinks
three times.
Blinks
three times.
ESC
ESC
U
L
／
CONT 8・・・・・・CONT 1
To Next Page
Loading...