CHAPTER 14 PC LOADER
Detail Description of Function 14-33
14
(12) Forced OUT signal output
(13) Forced pulse output
Select the OUT signal output at (a) and select ON or OFF at (b).
To exit from this mode, turn the power off.
(a)
(b)
Select the pulse signal to be output, at (a).
A,B-phase
Enter the frequency and press the "Forced pulse output"
button to issue pulses.
Frequency setting range: 0 to ±1000 kHz in increments
of 1 kHz
Z-phase
The Z-phase signal alternates each time the "Forced H
signal output" or "Forced L signal output" button is
pressed.
To exit from this mode, turn the power off.
(a)
To Next Page
Loading...