Introduction
K-Frame Standard Frame
20
• 4K UHD using 2SI (2 Sample Interleave) or SDQS (Square Division Quad Split) is
converted to 2160p video for internal processing using hardware on the IP and
SDI I/O Boards.
• Integrated Macro Builder/Editor allows users to edit macros online or offline on a PC
running the menu application.
• Optional DoubleTake™ (split M/E mode) effectively increases the number of M/Es and
adds flexibility to Suites operation while FlexiKey™ programmable clean feed mode
supports separately programmable configurations of keyers from four M/E outputs.
• FlexiKey™ programmable clean feed mode supports separately programmable
configurations of keyers from four M/E outputs.
• Aux bus transitions for dissolves and wipes on aux bus outputs.
• Interfaces with Grass Valley routers supporting Native Protocol.
• Optional Integrated Image Store capable of delivering up to 32 GB, 64GB or 128GB
storage of Stills (3,000/6,000/12,000 images) or “Movies” (a total of 50 seconds, 1 minute
40 seconds or 3 minutes 20 seconds) of 1080p video or up to 50 seconds of 2160p video.
• LDK Series and LDX Series camera control with Ethernet tally via Connect Gateway.
• 999 macros with many ways to recall macros from the Control Panel.
• 1,000 E-MEM registers with Define E-MEM for fine control in creation and editing of
effects.
• Optional M/E Previewer (ME-View) provides a method to check and monitor any input to an
M/E on a single output.
• SERIA
L OR Ethernet VDCP control.
• Ethernet tally connection for integration with external tally systems.
• Optional RGB color correction on M/E buses and aux bus outputs.
• Source Rules:
• Links keyers to sources.
• Settings for On/Off/Left Alone on every M/E.
• Full look-ahead preview of rules.
• Hot-swappable, front/rear removable modules and power supplies.
• Optional multiple Multiviewer capability with 6 pre-configured layouts (maximum 16
panes per layout) with On-Air and Preview tally.
K-Frame XP Standard Frame
• Up to 192 inputs and 96 outputs.
• Up to 9 VPEs which can be used as MEs or Multiviewers
• Up to 9 M/Es, accessible across four suites—by using DoubleTake this may be increased
to 18 virtual M/Es.
• Every M/E has six keyers with standard keying modes including Chroma Key with two
frame stores per keyer.
• 2D-DPMs with perspective on every keyer, so iDPMs can be utilized for more
complex effects.
• Up to 16 iDPMs (Integrated Digital Picture Manipulators), assigned as either floating
iDPMs on any keyer or within an eDPM at user’s discretion.
To Next Page
Loading...
