GRASS VALLEY KAYENNE - Fire Xpression GPI Sets; Kayenne Device Control from the Control Panel

Device Control
Local Aux Module
238
data pad and entering an ID and selecting Enter.
3 Use the function buttons in the Extended pane to set controls for IDs, Buffers and
Layers
Fire XPression GPI Sets
There are four XPression GPI Sets that can be fired from the GV switcher, GPI Set 1-GPI Set 4.
There is macro support for firing the GPIs. Creating a macro to fire a GPI means the GPI ID
you preset to one of the four GPI buttons will be fired when the macro is triggered; not
GPI 1 through GPI 4 presets but the GPI ID assigned to each.
1 Select Devices, GFX in the menu.
2 Select a GPI number you have configured in the external device by either scrolling with
the soft knob or selecting the GPI data pad and entering the GPI and selecting
Enter.
Repeat for each GPI Set preset.
3 Select one of the GPI presets, then select
Fire GPI.
Note: Only one GPI preset can be fired at a time.
You can also create a macro to select and fire the GPI preset ID, from the Control Panel or
Macros menu.
Kayenne Device Control from the Control Panel
The following provides device control operations from the Kayenne system: