GRASS VALLEY KAYENNE - Perform a Modify All Operation; About E-MEM Learn Auto Recall; Update E-MEM Register Header Information; Set the Enable Groups Associated with Auto Recall

Kayenne/Karrera/GV Korona
User Manual
279
Perform a Modify All Operation
1 Delegate for editing the levels in the effect you wish to be affected by the
modifications.
2 Move the time cursor to the location in the effect you wish to use as a baseline for the
operation.
3 Change the desired parameters by pressing a button, turning a knob, or entering a
value with the key pad.
4 Perform the desired relative or absolute modify operation:
• To make relative changes, access the Timeline Edit menu by selecting
E-MEM &
Timeline
, Timeline Edit, then select the Mod All Relative button. The relative changes
of the modified parameters will be applied to all the affected keyframes in the effect.
• To make absolute changes, access the Timeline Edit menu by selecting
E-MEM &
Timeline
, Timeline Edit, then select the Mod All Absolute button. The absolute values
of the modified parameters in the work buffer will be applied to all the affected
keyframes in the effect.
Note: When using the Modify All Absolute feature, it is recommended
that only one parameter at a time is modified to prevent, for example, all
keyframes being moved to the same position.
About E-MEM Learn Auto Recall
Each E-MEM register contains header information, along with keyframe data. Header
information applies to the entire effect and is not keyframable. Register header information
includes:
• E-MEM enable group button selections (for Auto Recall)
• Effect Dissolve state (on or off)
• Effe
ct Dissolve rate (seconds, frames, field)
When an effect is edited in the standard manner (Insert Before/After, Modify Keyframe,
Modify All), only keyframe data is affected. The header information does not change. In a
standard Learn operation, all existing keyframe data is overwritten with a single keyframe,
and new header information is saved.
Update E-MEM Register Header Information
Learn Auto Recall can be used to update E-MEM register header information without
changing keyframe data.
1 In the Master E-MEM Module of the Control Panel, select the state of the desired header
information.
2 Press
LRN, Auto Recall.
Set the Enable Groups Associated with Auto Recall
Levels of the switcher can either be included or excluded from Auto Recall using the level
buttons in the Master E-MEM Module of the Control Panel.
1 Press
Auto Recall in the Master E-MEM Module so it is on.
2 Press to enable the level buttons in the Master E-MEM you wish to include with Auto