GRASS VALLEY KAYENNE User Manual

Switching Basics
Perform Aux Bus Transitions
218
Perform Aux Bus Transitions
1 Go to the User Setups, Suite Prefs, Resource Allocation menu.
2 Select the button(s) of the M/E partition you wish to allocate as the transition resource
for the aux bus.
3 Press the
Aux Trans button in the Application column.
4 To change the transition rate, press the Aux Transition Rate parameter button, enter a
transition rate in the pop-up keypad, and press
Enter.
The Mix and Wipe buttons on the Local Aux Module are now low tally.
5 Select an Aux bus on the Local Aux Module.
6 Press the Mix or Wipe button.
7 Press the
Trans Lock button if you wish the mix/wipe transition to remain selected.
The aux bus is ready for transition to the next source.
Note: If you attempt an Aux bus transition while all allocated M/E
transition resources are in use, the Aux bus will perform a cut (not a
transition). For example if during a long transition where allocated
resources are all in use, and you switched sources during the transition,
the Aux bus would ‘cut’ to the selected source (it would not mix or wipe).

GRASS VALLEY KAYENNE Specifications

General

Brand	GRASS VALLEY
Model	KAYENNE
Category	Recording Equipment
Language	English