Device Control
Camera Operations
260
b If the Auto Recall button is off, the sources currently selected in the Switcher source
pane will be updated with the R-MEM values of that register.
Note: A switcher source that is currently on-air with an On Air protection
status cannot be changed by an R-MEM recall. Either place the source off-
air or select a different protection status to change the switcher source
selection.
About E-MEM Control of R-MEM
R-MEM can be assigned to an E-MEM Enable group, to permit E-MEM control of R-MEM
settings. R-MEM information is learned to the R-MEM level of an E-MEM register, allowing
the selection of specified router sources when that E-MEM register is recalled. One R-MEM
setting is supported per effect (R-MEM is not keyframeable).
Because R-MEM is a level of E-MEM, there is a one-to-one correspondence between E-MEM
and R-MEM registers. For example, settings in R-MEM register 10 only apply to E-MEM
register 10. This is similar to the relationship between an individual M/E E-MEM and the
Master E-MEM system. R-MEM information is added to an E-MEM register using the Learn
operation or the Learn Mod operation.
R-MEM Disk Storage
While R-MEM is organized operationally as a level of an E-MEM register, R-MEM data is
saved to disk separately, as R-MEM registers. This allows added flexibility. For example, the
same E-MEM effect can use different router source selections or enables, depending on
which R-MEM register has been loaded from disk.
R-MEM Enable Control and Auto Recall
R-MEM also provides an additional level of control. R-MEM has its own set of enables that
control which sources (router destinations) are affected by a recall operation. This aspect of
R-MEM is like the enable groups used for Master E-MEM. The Auto Recall button on the
R-MEM menu controls R-MEM recalls similar to the control the Auto Recall button in the
Control Panel Master E-MEM Module exerts over E-MEM recalls. These are separate
functions affecting different control elements, however.
An e
xample of using this is to control which router sources will be changed without having
to learn a new E-MEM register for each variation. Suppose you learn an R-MEM specifying
router sources for several switcher sources, create an E-MEM effect using those sources, and
learn that E-MEM with the R-MEM Enable button selected. Recalling that E-MEM with the
Master E-MEM Auto Recall button on, will also recall that R-MEM. If the R-MEM Auto Recall
button is also on, the enabled switcher sources will select the specified router sources. If the
R-MEM Auto Recall button is off, only the switcher sources enabled on the R-MEM menu will
be affected by the recall. Disabling all the switcher sources on the menu makes the E-MEM
recall use the currently selected router sources, with no changes.
E-MEM Prefs Assignment
By default R-MEM is not assigned to any E-MEM Enable group button. You use the E-MEM
Prefs menu (accessed in the User Setups, Suite Prefs, E-MEM Prefs menu), to make an
assignment. Select the R-MEM data pad, then select the desired Enable button.
Once this assignment has been made, recalling an E-MEM register in the Master E-MEM
To Next Page
Loading...
