GRASS VALLEY KAYENNE - About Multi-Function Module Device Control

Kayenne/Karrera/GV Korona
User Manual
241
About Multi-Function Module Device Control
The Kayenne Multi-Function Module supports Single and Multiple Device Control. In Single
Device Control mode, you have full VTR control of an Event List right on the Control Panel.
In Multiple Device Control mode, you can select and control up to eight devices at a time
from the Control Panel, with Stop, Cue, and Play for each (including gangs).
Single Mode Device Control
To place the Multi-Function Module in Single Device Control mode, press the Devs button
from the HOME position, then press the
Sngl button located below and right of the joystick
on the Multi-Function Module.
Follow Mode Device Control
When in Follow mode, the default, the Multi-Function Module tracks the right-most Device
Control group on the System Bar (see System Bar, on page 237). The current device is shown
in the function button status display just below the Joystick, on the right side of the Multi-
Function Module. ‘Device Follow’ is displayed in the LED to the right of the top soft knob.
Single Device Control, Follow Mode
Device Selection
Device Selection is performed by turning the top soft knob. Turning this knob in Device
Control mode scrolls through the associated devices (seen in the status display). Turning
the soft knob immediately delegates the Multi-Function Module to the newly selected
device.
Pushing down the top soft knob returns the Multi-Function Module to the Follow mode.
8623267_18
Key Key Key Key Key Key Wiipe Wiipe
1 2 3 4 5 6 1 2
Clip+1
- - -
K2-3-3
BEGN REW JOG-STOP PLAY JOG+ FF END
Clip+2
- - -
Clip+3
- - -
MULT
HOME
ADV APLY CUE
Cur Clip
Sprt-Fill
01:0 0:20 :00 GOTO Adel Last
DEVICE
FOLLOW