GRASS VALLEY KAYENNE - Edit Macro Builder Created Macros

Kayenne/Karrera/GV Korona
User Manual
303
3 Select an area of the switcher system—ME 1.
4 Make the next selection—
Transition.
5 Make the next selection—
Primary.
6 Make the next selection—Transition Type.
7 Make the next (and in this case the last) selection—
Wipe 1.
8 Select the
Apply button that is displayed when the final step of the macro has been
completed.
Result: The macro to transition Wipe 1 is added to the macro register.
Edit Macro Builder Created Macros
Lines in a macro supported by the Macro Builder can be edited by selecting the Edit Line
Macro Builder button and selecting a new parameter. In this example, the Wipe 1 transition
in this macro will be changed to Wipe 2. The Single Step button located at the top right of
the menu is provided to step through each line.
Note: If the Macro Builder Edit Line button is selected but the macro
command in the line is not supported by the Macro Builder, the Macro
Editor will open the more complex editing menus automatically.
1 Select Macros, Catalog then select the macro to be edited.
2 Select the
Edit button in the Macro Edit/Build pane (lower right).
3 Select a line to be edited; in this example a Wipe 1 transition.
4 Select the Edit Line button of the Macro Builder button pane.
5 Select Wipe 2 and select Apply.