GRASS VALLEY KAYENNE - Editing a Video Clip with Build Edit

Kayenne/Karrera/GV Korona
User Manual
397
will be overwritten when creating a sub-clip using the Make Clip operation.
Editing a Video Clip with Build Edit
The following examples demonstrate how to mark-in, mark-out, mark a thumbnail, and
make a sub-clip. The
Use Audio From Video and Use Key From Video buttons are enabled
(highlighted green) which means only the video track will be edited and a new clip made
with those changes:
Mark In/Out
Select Image Store, ClipStore, Clip Edit and select the Build button in the Edit Type mode
button group.
1 Unless the desired clip is loaded, select the Video Thumbnail Viewer.
2 Select the
Change Clip button for the Video and select the desired clip.
3 Determine where you want a mark-in point for the Video track by either
playing/jogging to the mark while viewing the clip on a monitor and selecting the
Mark In button or if you know the timecode, select the Mark In data pad and enter the
timecode into the pop-up keypad, and select
Enter.
4 Determine the mark-out point for the Video track and enter it as described for Mark In.
Mark a Thumbnail
1 Jog, shuttle, or play to where you want to mark thumbnail and select the Mark
Thumbnail
data pad, or
2 Select the
Mark Thumbnail data pad and enter the mark-thumbnail point in the pop-
up keypad, and select Enter.
With the Video Thumbnail Viewer selected, you can test the composite elements using
the motion control buttons.