GRASS VALLEY KAYENNE - Page 326

Advanced Operations
Corner Pinning from the Kayenne Control Panel
330
The CPin (Corner Pinning) button is in the iDPM menu of the MFM.
iDPM Menu—Multi-Function Module
Corner Pinning and Crop controls are located in the CPin MFM Module menu. Press the CPin
button to enable/disable Corner Pinning, press the Dlg button directly below to turn on
Corner pinning and adjust the Corner Pinning parameters using the soft knobs.
Note: Corner Pinning and Crops have their own path controls, however
each corner and each crop edge share the same path. See Change Path
Control Values in an Effect, on page 280 for more information about
paths.
iDPM, CPin (Corner Pinning) Menu—Multi-Function Module
8623267_29
Wipe
1 2
Y
Thru
PGM Dlg
Dlg
CPin Crop Thru
Thru
50.%
iDPM All
B/L B/R
-9.000
T/L T/R
Adel Last
9.000