Kayenne/Karrera/GV Korona
User Manual
399
In the Audio area (center):
1 Turn off the
Use Audio From Video button by selecting it.
2 Select the
Audio Thumbnail Viewer.
3 Select the
Change Clip button and select the desired clip/.WAV file with the desired
Audio track.
4 Synchronize the Audio track in relation to the current video track timecode position, if
needed, using the
Hold Sync data pad or the Audio Offset soft knob (see Hold Sync, on
page 399).
5 With the Video Thumbnail Viewer selected (Video area, top), you can test the composite
elements using the motion control buttons.
Make the Sub-Clip
1 Select the Make Clip button (bottom right of menu).
2 Enter the name of the new clip and select
Enter.
Add/Replace a Key Element with Build Edit
In this case, you use the video and audio of the loaded video element but add/replace the
key track and make a sub-clip. The Use Audio From Video button is enabled (highlighted
green):
1 Unless the desired clip is loaded, select the
Key Thumbnail Viewer.
2 Select the
Change Clip button in the Key area (bottom) and select the desired clip.
3 If selected, turn off the Use Key from Video button.
4 In t
he Video area, determine where you want a mark-in point for the key track by either
playing/jogging to the mark while viewing the clip on a monitor and selecting the
Mark In button or if you know the timecode, select the Mark In data pad and enter the
timecode into the pop-up keypad, and select
Enter.
5 Determine the mark-out point for the Video track and enter it as described for Mark In.
6 Synchronize the Key track in relation to the current video track timecode position, if
needed, using the
Hold Sync data pad or the Key Offset soft knob (see Hold Sync, on
page 399).
7 With the
Video Thumbnail Viewer selected, you can test the composite elements using
the motion control buttons.
8 Select the
Make Clip (bottom right of menu) button.
9 Enter the name of the new clip and select
Enter.
Join Edit a Clip
Join Edit allows you to append one clip to another, and mark a thumbnail if desired.
1 To go to the Join Edit mode menu, select Image Store, ClipStore, Clip Edit and select
the Join button in the Edit Type mode group.
To Next Page
Loading...
