Kayenne/Karrera/GV Korona
User Manual
85
Each Key Store can save the use of other switcher resources. For example instead of using
an Image Store channel or another keyer, you could store a station ID or a replay graphic
(still) for a sports show in a Key Store and switch the image within the keyer.
In the Keyer, Key Store menu, each Store has two frames, Frame Store 1 and Frame Store 2.
Each can ‘Grab’, ‘Store’, and ‘Use’ a still image for a key source. So in addition to Live video,
you have up to two fill/cut images that can be interchanged on any full keyer source.
• The
Show Key button—Shows the cut signal for the selected Key Store source.
• The Push to Preview button—Shows the current Key Store image on Preview.
The fill and cut from Live, Frame Store 1, and Frame Store 2 pages can be used in any
combination, for example you can use the fill from Keyer Video Source, Frame Store 1 with
the cut from Keyer Cutout Source, Frame Store 2. You can even use the Live video from the
Keyer Video Source and the cut from Keyer Cutout Source, Frame Store 1.
On power cycle or reboot, Key Stores will have to be reloaded with the correct video. They
default to black keyed with black which will not show up on a monitor.
Key Store is E-MEMable and keyframeable.
Grabbing a Key Store Image
The keyer settings are defined in the Eng Setup, Source Definition menu where for example
you can set a key to a Linear or Shaped Video. You will need to define these parameters
when creating a Key Store, if not defined the key will be full raster white.
To Next Page
Loading...
