Huawei Quidway S5600 Series - Page 660

Operation Manual - DHCP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2
DHCP Server Configuration
Huawei Technologies Proprietary
2-30
 Note:
z Perform the operations listed in Table 2-24 in system view if you specify to assign
IP addresses of an interface-based address pool to DHCP clients.
z This method allows you to configure the option 184 supporting function for multiple
interfaces.
II. Configuring the option 184 supporting function in interface view
Table 2-25 Configure the option 184 supporting function in interface view
Operation Command Description
Enter system view
system-view
—
Enter interface view
interface interface-type
interface-number
—
Configure an IP address for the
interface
ip address ip-address
net-mask
—
Configure the interface to
operate in DHCP server mode
and assign the IP addresses of
an interface-based address
pool to DHCP clients
dhcp select interface
Required
Configure the NCP-IP
sub-option
dhcp server voice-config
ncp-ip ip-address
Required
Configure the AS-IP sub-option
dhcp server voice-config
as-ip ip-address
Optional
Configure the voice VLAN
configuration sub-option
dhcp server voice-config
voice-vlan vlan-id { enable |
disable }
Optional
Configure the Fail-over routing
sub-option
dhcp server voice-config
fail-over ip-address
dialer-string
Optional