Huawei Quidway S5600 Series - Page 661

Operation Manual - DHCP
Quidway S5600 Series Ethernet Switches-Release 1510 Chapter 2
DHCP Server Configuration
Huawei Technologies Proprietary
2-31
 Note:
z Perform the operations listed in Table 2-25 in interface view if you specify to assign
IP addresses of an interface-based address pool to DHCP clients.
z This method allows you to configure the option 184 supporting function for a
specific interface.
III. Configuring the option 184 supporting function in global DHCP address
pool view
Table 2-26 Configure the option 184 supporting function in global DHCP address pool
view
Operation Command Description
Enter system view
system-view
—
Configure the interface to
operate in DHCP server
mode and assign the IP
addresses of an
interface-based address
pool to DHCP clients
dhcp select global { all |
interface interface-type
interface-number [ to
interface-type
interface-number ] }
Required
Enter DHCP address pool
view
dhcp server ip-pool
pool-name
—
Configure an IP address
range IP addresses in
which are dynamically
assigned
network ip-address
[ mask netmask ]
—
Configure the NCP-IP
sub-option
voice-config ncp-ip
ip-address
Required
Configure the AS-IP
sub-option
voice-config as-ip
ip-address
Optional
Configure the voice VLAN
configuration sub-option
voice-config voice-vlan
vlan-id { enable | disable }
Optional
Configure the Fail-over
routing sub-option
voice-config fail-over
ip-address dialer-string
Optional