Chapter 6 Error List 6.2 Error List (MAIN Application)
225
Error No. Error name Description, action, etc.
C0E BGSR no pair-end error
There is no EDSR for BGSR, or no BGSR for EDSR. Check the correspondence between BGSR
and EDSR.
C0F DO/IF/IS over-nesting error
The number of nests in a DO or IF/IS command exceeds the limit value. Check for excessive
nesting or branching out of or into the syntax using a GOTO command.
C10 SLCT over-nesting error
The number of nests in a SLCT command exceeds the limit value. Check for excessive nesting or
branching out of or into the syntax using a GOTO command.
C11 Subroutine over-nesting error
The number of nests in a subroutine exceeds the limit value. Check for excessive nesting or
branching out of or into the syntax using a GOTO command.
C12 DO/IF/IS under-nesting error
The EDIF or EDDO position is invalid. Check the correspondence between IF/IS command and
EDIF or DO command and EDDO, or branching out of or into the syntax using a GOTO command.
C13 SLCT under-nesting error
The EDSL position is invalid. Check the correspondence between SLCT and EDSR, or branching
out of or into the syntax using a GOTO command.
C14 Subroutine under-nesting error
The EDSR position is invalid. Check the correspondence between BGSR and EDSR, or
branching out of or into the syntax using a GOTO command.
C15 SLCT next-step command code error
The program step next to SLCT must be WHEQ, WHNE, WHGT, WHGE, WHLT, WHLE, WSEQ,
WSNE, OTHE or EDSL.
C16 Create stack failed Initialization of the input-condition-status storage stuck has failed.
C17 Expansion-condition code error Input program step error. The expansion condition code is invalid.
C18
Expansion-condition LD simultaneous processing over
error
The number of LDs processed simultaneously exceeds the limit value.
C19 Expansion-condition LD shortage error 1 There is not enough LD when expansion condition A or O is used.
C1A Expansion-condition LD shortage error 2 There is not enough LD when expansion condition AB or OB is used.
C1C Unused-LD detection error
An attempt was made to execute a command based on multiple LD condition
that has been saved, without using it in expansion condition AB or OB.
C1F Input-condition CND shortage error The necessary input condition is not found when an expansion condition is used.
C21
Input-condition use error with input-condition prohibited
command
Input-condition prohibited commands prohibit the use of input conditions.
C22
Invalid command position error with input-condition
prohibited command
A command for which input condition is prohibited cannot be included in an input condition nest.
C23 Invalid operand error Program step error. The necessary operand data is invalid.
C24 Operand type error Program step error. The operand data type is invalid.
C25 Actuator control declaration error The setting of actuator control declaration command is invalid.
C26 Timer setting-range over error The timer setting is invalid.
C27 Timeout setting-range over error during wait The timeout setting is invalid.
C28 Tick count setting-range error The Tick count setting is invalid.
C29 DIV command divisor 0 error “0” was specified as the divisor in the DIV command.
C2A SQR command range error
The operand value in the SQR command is invalid. Input a value larger than “0” as data in a SQR
command.
To Next Page
Loading...