LANDING GEAR / BRAKE LINE 14-29
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
FIGURE 14-12
BRAKE LINE REPLACEMENT
VERIFICATION METHOD:
Bleed the brakes per the procedure in the Beringer manual. Check for correct operation and no leaks.
RELATED INFORMATION:
"Wheel and Brake System Maintenance" on page 14-18
"General Brake Line Termination Procedure" on page 14-29
14.5.1.2 General Brake Line Termination Procedure
Use the following procedure for preparing and cutting the brake line to length and adding banjo fittings.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
HDB01 Stainless Steel Braided Hose
To Next Page
Loading...
