LANDING GEAR / BRAKE LINE 14-33
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
RELATED INFORMATION:
"Wheel and Brake System Maintenance" on page 14-18
"General Brake Line Termination Procedure" on page 14-29
14.5.1.3.1 Parking Brake Valve Removal Procedure
Use the following to remove the parking brake valve.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
11—Landing Gear
Consumables
None
1. Unless already performed, remove any interior panels needed to gain access to the parking
brake valve.
2. Remove bolts and neoprene washers from parking brake valve.
3. Remove AFT brake lines from parking valve. Use a wrench to hold the fitting on the forward port
of the parking valve, then a 1/2” wrench to disconnect the B-nut of the brake lines at the parking
valve.
4. Cap or plug the openings to minimize fluid loss.
VERIFICATION METHOD:
Verify that the parking brake valve is fully removed.
To Next Page
Loading...
