ICON A5 - Page 635

PROPULSION / ENGINE 16-11
CHANGE C2 ICON A5 / MAINTENANCE MANUAL
CHAPTER 16
EGT (Exhaust Gas
Temperature
Sensor) Cylinder X
“ENGINE” /
“LAND
AIRCRAFT +
ENGINE” Light
EGT failure Locate and replace failed EGT.
See “Remove Exhaust System”
on page 16-49. See “Install
Exhaust System” on page 16-51.
Throttle Position Malfunctioned
Manifold Air
Pressure Sensor
(MAPS)
Check for connection and signs
of corrosion, clean, and reinstall.
See “Rotax 912 iS Sport (912 iS
2) Heavy Maintenance Manual”.
Throttle Position
Sensor issue
Check throttle cable connection
to the engine throttle valve. See
“Rotax 912 iS Sport (912 iS 2)
Line Maintenance Manual”.
Check and adjust throttle
rigging. See “Inspect Throttle
Control for Proper Travel and
Security” on page 16-32.
Engine Ambient
Pressure
Defective
connection sensor
connection
Check the wiring and
connections of the AAPTS
sensor. Remove the AAPTS
sensor and inspect for debris or
oily residue. If problem persists,
replace AAPTS sensor as
necessary.
Engine Ambient
Tem p erature
Engine Ambient
Pressure
(Advanced BIT
Engine On)
Malfunctioned
Manifold Air
Pressure Sensor
(MAPS)
Check for connection and signs
of corrosion, clean, and reinstall.
Replace if necessary. See
“Rotax 912 iS Sport (912 iS 2)
Heavy Maintenance Manual.
Replace air filter. See “Replace
Engine Air Filter” on page 16-48.
Engine Ambient
Temperature
(Advanced BIT
Engine On)
Clogged air filter
Error Message
Additional
Symptom
Possible Cause Remedy