Figure 173: View mode – with Snapshot tool 151
Figure 174: Screen capture thumbnail is displayed after taking a screen capture 152
Figure 175: Screenshot with an annotations toolbar 152
Figure 176: Annotations toolbar 153
Figure 177: Adding text to the screenshot 153
Figure 178: Screenshot with annotations 154
Figure 179: Notification that the screenshots and annotations will be uploaded to MyiTero 154
Figure 180: Confirmation about the annotations being discarded 155
Figure 181: Notification that the screenshots will be uploaded to MyiTero 155
Figure 182: Option to download screenshots from the Orders page in MyiTero 156
Figure 183: Wand without a wand barrier sleeve 158
Figure 184: Remove gross contaminants using CaviWipes1 159
Figure 185: Remove marks and stains using a soft bristle brush 159
Figure 186: Wipe the optical surface of the wand with IPA 160
Figure 187: Release and remove the vent cover 161
Figure 188: Insert the tip of the wand into the new vent cover 161
Figure 189: Pull on the vent cover until it locks into place 161
Figure 190: Check that the rear end of the vent cover reaches the cable cap 162
Figure 191: Remove gross contaminants on the cradle using CaviWipes1 163
Figure 192: Remove remaining marks and stains on the cradle using the soft bristle brush 163
iTero Element® 5D Plus User manual
xvi © 2020 Align Technology, Inc. All rights reserved.
To Next Page
Loading...
