Or
Tap to search for an existing patient, as described in section 4.3.2.
2. In the Order area, from the Case Type drop-down list, select the required case type.
Note: The list of case types displayed depends on your subscription package.
Figure 85: Selecting the required case type
The following case types are available by default, depending on whether you have a Restorative or Orthodontic
subscription package:
o
iRecord: A simple scan with no additional modification, mainly used for referencing and instead of storing the
plaster model, as required by law. (This case type can later be changed to iCast or Invisalign, if required.)
o
Chair Side Milling: A restorative scan without the need to send the scan to a laboratory for modeling and
milling.
o
iCast: The same as iRecord, but showing the ABO model and a modeling step that can remove unused data
and adjust the bite if needed. (This case type can later be changed to Invisalign, if required.)
o
Invisalign: The basic scan for Invisalign treatment. The model must be scanned without any holes to ensure
that the aligners are a perfect fit with the patient’s teeth.
o
Vivera: A simple scan with no additional modification, for the creation of a clear retainer that is similar to a
single Invisalign aligner, which maintains the position of the teeth after treatment.
o
Vivera Pre-Debond: A scan used on patients while their brackets are still attached. The Vivera retainers are
then provided at the debonding appointment.
iTero Element® 5D Plus User manual
© 2020 Align Technology, Inc. All rights reserved. 77
To Next Page
Loading...
