EasyManua.ls Logo

Keba ServoOne - Page 345

Keba ServoOne
493 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
11.6.3.3Error2-3(emergencycode5530h)
Cause: Error in parameter saving routine
Suggested steps:
Switch off/on device. Please contact your service provider if this error occurs again
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
Anunexpectederrorinthe
filesystemhasoccurred.
l Pleasereportthiserrortoyourservicepartner.
l Pleasecheckwithyourservicepartnerhowto
generateanimagefileofthedrive.
l PleaseprovidetheDriveManagermessage
log.
Thisisprobablyasoftware
issue.
l Pleasetrytoswitchtoadifferentversionof
devicefirmware.
l Saveyourdatasetandresettheaxismoduleto
factorysetting.Seeiftheerrorpersists,orifit
comeswithactivatingacertainfeature.
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
345
11 Alarms & warnings
11.6.3.4Error2-4(emergencycode6320h)
Cause: Error in paralist while adding a new parameter
Suggested steps:
Switch off/on device. Please contact your service provider if this error occurs again
Thisisprobablyasoftware
issue.
l Pleasetrytoswitchtoadifferentversionof
devicefirmware.
l Saveyourdatasetandresettheaxismoduleto
factorysetting.Seeiftheerrorpersists,orifit
comeswithactivatingacertainfeature.
11.6.3.5Error2-5(emergencycode5530h)
Cause: Parameter check failed
Suggested steps:
Switch off/on device. Please contact your service provider if this error occurs again
Thisisprobablyasoftware
issue.
l Pleasetrytoswitchtoadifferentversionof
devicefirmware.
l Saveyourdatasetandresettheaxismoduleto
factorysetting.Seeiftheerrorpersists,orifit
comeswithactivatingacertainfeature.

Table of Contents

Related product manuals