Keba ServoOne - Page 346

To Next Page

To Previous Page

11.6.3.6Error2-6(emergencycode6320h)

Cause: Parameter ID is multiply defined

Suggested steps:

Switch off/on device. Please contact your service provider if this error occurs again

Thisisprobablyasoftware

issue.

l Pleasetrytoswitchtoadifferentversionof

devicefirmware.

l Saveyourdatasetandresettheaxismoduleto

factorysetting.Seeiftheerrorpersists,orifit

comeswithactivatingacertainfeature.

ID No.: 0842.26B.5-01Date: 09.2020

ServoOne- Device Help

346

11 Alarms & warnings

11.6.3.7Error2-7(emergencycode5400h)

Cause: Theselected switchingfrequencyis notsupported

Suggested steps:

Choose different voltage level and/ or switching frequency

Thisissueisprobably

causedbyanunsuitable

parametersetting.

l Saveyourparametersetforalaterrestore.

l See'historyofparameterchanges'andundo

thelatestchanges.

l Pleasecheckyourparametersetfor

implausiblesettings.

l Pleasesetdevicetofactorysetting,restart,and

seeiftheerroroccursagain.

l Whenreportingthiserrortoyourservice

partner,pleaseincludeyourdevice's