Keba ServoOne - Page 373

11.6.16.11Error15-12(emergencycodeFF00h)
Cause: Plant inertia / mass is invalid
Suggested steps:
Please specify motor inertia or try to identify plant inertia
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
11.6.16.12Error15-13(emergencycodeFF00h)
Cause: Drive comissioning: Watchdog failure via service tool access
Suggested steps:
Check your network connection
ID No.: 0842.26B.5-01Date: 09.2020
ServoOne- Device Help
373
11 Alarms & warnings
11.6.16.13Error15-14(emergencycodeFF00h)
Cause: Drive initialization: Unexpected error during drive initialization
Suggested steps:
Check the drives parameter settings
Thisissueisprobably
causedbyanunsuitable
parametersetting.
l Saveyourparametersetforalaterrestore.
l See'historyofparameterchanges'andundo
thelatestchanges.
l Pleasecheckyourparametersetfor
implausiblesettings.
l Pleasesetdevicetofactorysetting,restart,and
seeiftheerroroccursagain.
l Whenreportingthiserrortoyourservice
partner,pleaseincludeyourdevice's
parametersetting.
11.6.16.14Error15-15(emergencycodeFF00h)
Cause: Parameter: Auto save to MMC failed
Suggested steps:
Check MMC or disable function