KNK Zing - Suggested Settings for Various Accessories 1

180
Suggested Settings for Various Accessories
1
Application/Material
Tool
Force
Speed
(Cut/Up)
#
Passes
Surface
Other Comments
Drawing on paper
Sharpie
Marker
20
10/10
1
Mat
Pen was almost touching paper in order to be
grasped by front screw
Drawing on paper
Sharpie
Liquid
Pencil
40
10/10
2
Mat
Used 2 passes because pencil hesitates to
start drawing each time.
Drawing with glue on
paper
Sakura
Quickie
Glue Pen
30
9/10
2
Mat
2 passes provided a little more glue. Also used
0.01" Inset Shadow and Outset Shadow to
provide a thicker outline of shape.
Embossing Cardstock -
Georgia Pacific 100#
Embossing
- large end
95
9/10
3
Shelf
Liner
Used 0.01" Inset Shadow and Outset Shadow
to provide a thicker outline of shape.
Scoring Cardstock -
Georgia Pacific 100#
Embossing
- small end
150
10/10
2
Shelf
Liner
Scoring Cardstock -
Recollections
Embossing
- small end
150
10/10
2
Shelf
Liner
Engraving Vellum - 48#
Engraving
100
10/10
2
Mat
Used 0.01" Inset Shadow and Outset Shadow
to provide a thicker outline of shape.
Engraving Vellum - thin
Engraving
50
10/10
2
Mat
Used 0.01" Inset Shadow and Outset Shadow
to provide a thicker outline of shape.
Engraving Metal Dog
Tag
Engraving
140
9/10
3
Mat
Punching Cardstock -
Georgia Pacific 100#
Punching
85
10/10
2
Shelf
Liner
1
These settings should be used for the initial testing. Adjustments may be necessary based on variations in the material,
surface beneath paper, humidity, condition of the cutting mat, etc. Most tests were done with a blade tip height equal to a
stack 25 Post-it notes or 12 Georgia Pacific 100# cardstock pieces.
Important: Remember to turn Blade Offset back on after using
accessory tools and before cutting with your blade again!