Korg Oasys - Page 141

Sampling and editing in Sampling mode
133
–SamplingSetup–
SourceBus:L/R
ThesoundbeingsenttotheL/Rbuswillbe
sampled.
Trigger:Threshold
Withthissetting,samplingwillstartwhentheinput
exceedsaspecificvolume.
ThresholdLevel:–30dB
Fromtherecord‐readystate,recordingwillstart
automaticallywhentheaudioinputexceeds–30
dB.
PreTriggerREC:005ms
Recordingwillbeginimmediately(5ms)before
samplingisstarted,sothattheattackofthesoundis
notlost.
4. PresstheRecordingtabtoaccesstheP0:
Recording–Recordingpage.Makethefollowing
settings.
–RECSampleSetup–
Saveto:RAM
Youwillbesamplingto
RAMmemory.
Mode:L–Mono
ThesoundoftheinternalLchannelwillbesampled
inmono.
Set the recording level
5. Speakorsingatthevolumeyouintendtorecord.
Ifthe“A D C OVERLOAD!”(ADconverterinput
overload)indicationappears,turntherearpanel
LEVELknobtowardMINtoadjustthelevel
appropriately.
Forthebestsound,adjustthelevelashighas
possiblewithoutallowingthe“A D C OVERLOAD !”
indicationtoappear.
6. PresstheSAMPLINGRECswitch.
Speakintothemic,andnoticethatthelevelmeter
indicatesthevolumeofthesoundthatwillbe
recorded.
Ifthe“CLIP!”indicationappears,usetheVALUE
controllertolowertheRecordingLevelslider
(shownintherightofthedisplay)fromthe+0.0
settingtoanappropriateposition.
7. Whenyou’vefinishedmakingadjustments,press
theSAMPLINGRECswitch.
Record
8. PresstheSAMPLINGRECswitch.
TheOASYSwillbeinrecord‐readymode.
9. Speakintothemic,sayingtheword(s)youwantto
sample.
(Example:“It’s”)
Recordingwillstartwhenthelevelexceedsthe
Level–30dBsetting.
10.Whenyou’vefinishedsayingtheword(s),press
theSAMPLINGSTART/STOPswitch.