2NJ/2RK
2-114
10. Clean the bottom frame in front of the cassette heater with an alcohol.
11. Match the corner of the bottom frame marking (a) and attach the high temperature caution label (b).
Figure 2-219
12. Reattach the parts in the original position.
13. Turn the power on and set to [mode1/mode2] In maintenance mode U327 [Cassette heater control setting].
IMPORTANT
When connecting the cassette heater, do not unplug the power cord. (Power is supplied when the power is switched off)
Also, if unplugged for a prolonged time, it may cause blurred images depending on the environment. In this case, exe-
cute [System Menu] > [Adjustment/Maintenance] > [Drum Refresh] .
To Next Page
Loading...
