Kyocera TASKalfa 8002i

2WA/2NJ/2RK
6-64
Contents
Simulate the scanner operation in any condition.
Purpose
Execute the scanner operation to check the abnormal operation and dust adhesion on the slit
glass.
Method
1.Press the [Start] key.
2.Select the item to execute.
Setting: Scanner Motor
1.Select the item to set.
2.Change the setting value by using [+] [-] key or the numeric keypad.
Paper size corresponding to each set value
3.Press the [Start] key to set the setting value.
4.Select [Execute].
5.Press the [Start] key.
* :Scanning operation starts in a specified condition.
6.To stop the operation, press the [Stop] key.
U073 Scanner motor operation check
(Message: Check Scanner Motor Operation)
Items Contents
Scanner Motor Execute the scan operation
Home Position Home positioning operation
Dust Check Check if there is dust by turning the exposure lamp on
DP Reading scan position operation for the document processor
Items Contents Setting range Data
variation
Initial
setting
Zoom Magnification 25 to 400 (%) 1% 100
Size Original size 0 to 10200 100 10200
Lamp Turning the exposure lamp on/off 0: Off
1: On
-1
setting Destination setting Destination setting Destination
4300 B5 6100 B5R 8600 B4
5000 A4 6600 8 1/2"×11" 9000 11"×15"
5000 A5R 7100 A4R 10000 A3
5100 11"×8 1/2" 7800 Folio 10200 11"×17"
5100 5 1/2"×8 1/2" 8400 8 1/2"×14"