2WA/2NJ/2RK-2
6-63
Contents
Adjusts the DP original center line.
Purpose
Adjusted if there is a regular error between the center lines of the original and the copy image
when the DP is used
Adjustment
1.Press the [Start] key.
2.Press the [System Menu] key.
3.Place an original on the DP and press the [Start] key to make a test copy.
* :Check the duplex scanning by setting [Duplex] when test copying.
4.Press the [System Menu] key.
5.Select the item to adjust.
*: Initial setting value is a reference value as the value changes by the adjustment at the production.
6.By using the [+] [-] keys or the numeric keys, change the setting value.
For the copy example 1, decrease the value.
For the copy example 2, increase the value.
* :When the setting value is increased, the image moves to left, when the setting value is
decreased, it moves to right
Figure 6-15
7.Press the [Start] key to set the setting value.
Precautions
Check the 2nd side after adjusting the 1st side. Adjust if necessary.
Check the copy image after the adjustment. If the image is still incorrect, adjust the following in
the maintenance mode.
U034(P.6-38) > U065(P.6-54) > U067(P.6-57) > U072
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
U072 Adjusting the DP original center
(Message: Adjust DP Original Center)
Items Contents Setting range Data
variation
Initial
setting
Front DP center line. (Front page) -60 to 60 0.085 mm 0
CIS Adjusts the DPCIS center line -39 to 39 0.085 mm 0
Original Copy
example 1
Copy
example 2
To Next Page
Loading...
