2WA/2NJ/2RK
6-127
Contents
Turn the finisher's motors and solenoids on.
Purpose
Execute for the finisher's motors and solenoids operation check.
Method
1.Press the [Start] key.
2.Select the item to operate.
* :The screen for setting is displayed.
Method: Motor
1.Select the item to operate.
2.Press the [Start] key.
* :The operation starts.
U240 Finisher operation check
(Message: Check Finisher Operation)
Items Contents
Motor Finisher motor operation check
Solenoid Finisher solenoid operation check
Mail Box Mail Box motor operation check
Booklet Booklet operation check
Items Contents
Feed In(H) Drive the DF paper entry motor at a high speed.
Feed In(L) Drive the DF paper entry motor at a low speed.
Middle(H) Drive the DF middle motor at a high speed.
Middle(L) Drive the DF middle motor at a low speed.
Eject(H) Drive the DF eject motor at a high speed.
Eject(L) Drive the DF eject motor at a low speed.
Save(H) Drives the DF save drum motor at a high speed
Save(L) Drives the DF save drum motor at a low speed
Tray Drive the DF tray motor.
Operation pattern: After descending to the lower limit, ascends and
descends again when passing 1s after detecting the middle sensor off.
ascends again when detecting the middle sensor on and stops at the
upper limit.
Staple Move Drive the DF slide motor.
Staple Drive the DF staple motor.
Width Test(A3) Drive the DF side registration motor 1, 2.
Width Test(LD) Drive the DF side registration motor 1, 2.
Beat Drive the DF paddle motor.
Eject Unlock(HP) Drive the DF eject release motor at a home position.
Sort Test Execute the DF shift operation.
To Next Page
Loading...
