Kyocera TASKalfa 8002i - Page 818

2WA/2NJ/2RK
6-225
Sets the time to start ringing for an operator through the external telephone after receiving a call
in the FAX/telephone automatic switching mode. (See figure 1-3-27). Execute when a reception
error occurs when in the automatic FAX/telephone switching.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
2.Press the [Start] key to set the setting value.
* :[Completed] is displayed.
Setting: Tc Time Out
In the TAD mode, set the time to check if there are any triggers for shifting to FAX reception after
a connected handset receives a call. Unless switched to FAX reception during this period, oper-
ated as a normal phone after this.
In the TAD mode, change the setting when fax reception is unsuccessful or a telephone fails to
receive a call.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
2.Press the [Start] key to set the setting value.
* :[Completed] is displayed.
Setting: Td Time Out
Sets the length of time to determine silent status, one of the triggers for Tc time check.
In the TAD mode, change the setting when fax reception is unsuccessful or a telephone fails to
receive a call. Be sure not to set too short, otherwise the mode may be switched to fax while the
unit is being used as a telephone.
1.By using the [+] [-] keys or the numeric keys, change the setting value.
2.Press the [Start] key to set the setting value.
* :[Completed] is displayed.
Completion
Press the [Stop] key.
* :The screen for selecting a maintenance item No. is displayed.
Contents Setting
range
Initial
setting
Sets the Tb2 time-out time. 1 to 255 80
Contents Setting
range
Initial
setting
Sets the Tc time-out time. 1 to 255 s 60
Contents Setting
range
Initial
setting
Sets the Td time-out time. 1 to 255 6
30 (100 V model)
9 (120V model)