MacDon M105 - Closing Hood (Highest Position)

MAINTENANCE AND SERVICING
2. Locate latch (A) behind grill and lift to release hood.
3. Raise hood until strap (B) (which should be looped
under hooks [C] and [(D]) stops it at approximately a
40° angle.
4. Remove strap from hook (C) and allow hood to raise
slightly further.
5. Remove strap from hook (D) and allow hood to raise
fully to approximately 65°.
Figure 5 .
18: Accessing Engine Compartment
5.4.4 Cl
osing Hood (Highest Position)
1. Pull down on strap (B) and loop under lower hook (D).
2. Grasp the strap and loop under upper hook (C).
IMPORTANT:
Failur
e to hook strap may result in it becoming entangled
with th
e screen cleaners or the latch.
3. Pull down on strap, grasp the hood when within reach,
and lower until hood engages latch (A).
Fig
ure 5.19: Accessing Engine Compartment
169890 204 Revision A