MAINTENANCE AND SERVICING
End of Season Service
Perform the following at the end of each operating season:
CAUTION
Never use gasoline, naphtha or any volatile material for cleaning purposes. These materials may be toxic
and/or flammable.
1. Clean the machine thoroughly.
2. Store in a dry, protected place if possible. If stored outside, always cover with a waterproof canvas or other
protective material.
3. Raise header, and engage safety props (4.4.1 Header Safety Props, page 117).
4. If possible, block up the header.
5. Repaint all worn or chipped painted surfaces to prevent rust.
6. Loosen drive belts.
7. Lubricate the header thoroughly, leaving excess grease on fittings to keep moisture out of bearings. Apply
grease to exposed threads, cylinder rods, and sliding surfaces of c omponents. Oil cutterbar components to
prevent rust.
8. Check for worn components, and repair as necessary.
9. Check for broken components and order replacements from your MacDon Dealer. Attention to these items right
away will save time and e ffort at beginning of next season.
10. Replace or tigh ten any missing or loose hardware.
11. Remove tall crop dividers (if equipped) to reduce space required for inside storage.
169890 314 Revision A
To Next Page
Loading...
