MacDon M105 - Draper Speed; Draper to Ground Speed

OPERATION
c. Press FAST (C) or SLOW (D) until desired reel index is displayed.
Examples :
Windrower is operating at 8 mph with HEADER INDEX ON and set at -1.0.
• D isplay shows 7.0-1.0REELINDwhere 7.0 (8.0-1.0) is the reel speed in mph and -1.0 is the
HEADER INDEX setting.
Windrower speed drops to 7.5 mph at same HEADER INDEX setting.
• D isplay shows 6.5-1.0REELINDwhere 6.5 (7.5-1.0) is the reel speed in mph and -1.0 is the
HEADER INDEX setting.
Windrower is operating at 8 mph with HEADER INDEX ON and set at 2.0.
• D isplay shows: 10 .0 2.0 REEL IND where 10.0 (8+2.0) is the reel speed in mph and 2.0 is the
HEADER INDEX setting.
4.6.7 Draper Speed
Draper speed affects the orientation of stalks in the windrow. Faster draper speeds tend to form herringbone or
dovetail configurations. Refer to your header operator’s manual for guidelines on what speed to use.
The draper speed can be set with switches on the cab display module (CDM) relative to the ground speed of the
windrower with the HEADER INDEX function or can run independently.
Draper to Ground Speed
Setting
the speed of the draper relative to ground speed using the HEADER INDEX function allows you to run the
engine a
t lower rpm while maintaining the desired ground and draper speed. Reducing engine speed saves fuel
and red
uces noise in the ca b.
This mo
de re quires setting the MINIMUM DRAPER SPEED and setting the DR APER INDEX.
Refer t
o the following:
• Setting Draper Minimum Speed, page 172
• Setting Draper Index, page 173
169890
1
71
Revision A