MacDon M105 - Attaching a D-Series Header: Mechanical Center-Link

OPERATION
19. Connect header drive hoses (A) and electrical
harness (B) to header. Refer to the draper header
operator’s manual.
Figure 4.90: Header Drive Hoses and Harness
20. Connect reel hydraulics (A) at right-hand side
of windrower. Refer to the draper header
operator’s manual.
Figure 4.91: Reel Hydraulics
Attaching a D-Series Header: Mechanical Center-Link
NOTE:
This to
pic assumes that draper header boots have already been attached to the windrower lift linkage. If that is
not the
case, refer to 4.6.2 Attaching Header Boots, page 168.
To attach a D-Series header to a windrower equipped with a mechanical center-link, follow these steps:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
169890 136 Revision A