OPERATOR’S STATION
5. The CDM must be in programming mode to view the program menus. P ress PROGRAM and SELECT on the
CDM to enter programming mode. Exit programming mode at any time by pressing PROGRAM or by turning
ignition to OFF.
6. Refer to the Detailed Programming Menu Flow Chart, page 72 for a listing of a ll the menus with use r inf ormation
for each me nu item.
NOTE:
Contact your MacDon dealer for information about software updates to the electronic m odules. Your Dealer will
have the necessary interface tools and a ccess to the latest software upgrades
Detailed Pr
ogramming Menu Flow Chart
The programming menu flow chart is current for cab display module (CDM) software C107 and windrower control
module (WCM) software M102.
169890
7
2
Revision A
To Next Page
Loading...
