OPTIONS AND ATTACHMENTS
7.1.6 Draper H
eader Case Drain Kit
The Draper Header Case Drain kit must be installed when attaching a MacDon D50, D60, or D65 draper header
with an upper cross auger (UCA) but without double draper drive. Case Drain Kit (MD #B5842) is NOT required for
double draper drive headers equipped with kits (MD #B5606) and (MD #B5653).
MD #B5842
7.1.7 Draper Header Reel Drive and Lift Plumbing
Base kit required to run draper header. Includes draper header reel drive and lift plumbing (less valve) and reel
fore-aft hydraulics.
NOTE:
If the last
digit of windrower code is B, this bundle is already installed.
MD #B5577
Includes Instruction MD #169537.
7.1.8 E ngine Block Heater
Contact your nearest Cummins Engine Distributor, and provide your engine model and serial numbers to ensure
the proper heater is supplied.
7.1.9 E ngine Fan Air Baffle
Prevent
s the windrow from being disturbed by engine cooling fan air blast.
MD #B54
40
Instru
ction MD #169443 is included with the bundle
7.1.1
0 Expansion Module
Allows electronic monitoring of header knife speed, reel speed, and header angle. Also required for indexing reel
speed to g round speed. The windrower must be equipped w ith a hydraulic ce nt er-link (MD #B4 650 a nd #B 5269)
for header angle sensing: the header must be equipped w ith knife speed and reel speed sensors.
MD #B4666
Instruction M D #169392 is included with the bundle
7.1.11 HID A
uxiliary Lighting
Provides additional fi eld lighting. The kit includes two cab-mounted high intensity discharge (HID) lamps and
installation instructions.
MD #B5596
Instruction MD #169621 is included with the bundle
169890 338 Revision A
To Next Page
Loading...
