MacDon M105 - Ambient Light; Turn Signal Indicators; Circuit Breakers and Fuses

MAINTENANCE AND SERVICING
Ambient Light
To replace the ambient light fixture, follow these steps:
1. Shut down engine.
2. Locate the ambient light fixture (A) in the roof liner.
Figure 5.1
64: Ambient Light Fixture
3. Push against tabs (A) with a screwdriver and pull
ambient light fixture out of cab roof.
4. Remove wires from connectors (B).
5. Connect wires to new light fixture.
6. Push into place in cab roof until tabs hold fixture
in place.
Figure
5.165: Ambient Light Fixture
Turn Si
gnal Indicators
If the turn signal indicators on the cab display module (CDM) do NOT function, contact your MacDon Dealer.
Circuit Breakers and Fuses
The circuit breakers and fuses are located inside a fuse box mounted on the right (cab-forward) side of the frame.
The circuit breakers autom atically reset. Fu se s are the plastic blade type.
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
Access the breakers and fuses a s follows:
1. Stop engine and remove key.
169890 282 Revision A