CAB DISPLAY MODULE (CDM) ERROR CODES
Codes CDM Display Description
E41
E42 E142 REEL P4D Reel fore / aft solenoid P4D (V4D) fa ult detected
E43 E143 REEL UP/D OW N
P4B
Reel up / down
solenoid P4B (V4B) fault detected
E44
E45
E46 SENSOR VOLTS HIGH WCM’s 9V Sensor voltage output high. (wire 5019)
E47 SENSOR VOL
TS LOW
WCM’s 9V Se
nsor voltage output low. (wire 5019)
E48
E49
E50 B ATT+ OUT OF RANGE System voltage above 15.5 VDC.
Error codes E52 to E64 not allocated
E65
KNIFE OVERLOAD
Low knife spee d detected (less than pro grammed overload
speedinCDM)
E66 ##.# L
OW VOLTS
Low sy
stem voltage <11.5 VDC
E67 TR ANS OIL PRESSURE
Supercharge pressure low (switch 208 on hydraulic
schematic)
E68 TRANS Temp Oil Tank temp >221°F. / 105°C.
E69
E70
E71
LOW HYDRAUL IC OIL
Low hydraulic oil level sensor tripped. (switch 225 on
hydraulic schematic)
E72 ##.# HIGH VOLTS System voltage above 15.5 VDC
Error codes E73 to E100 not allocated
E101 SPI ERR OR J1939 Can Error
E102 CAN ERROR J1939 Can Error
E103 EEPROM R EAD ERR OR Internal E rror
E104
EEPROM W RITE ERROR
Interna l Err or
E105 TEMP SENSOR ERROR Internal Temperature Sensor Error.
169890 360 Revision A
To Next Page
Loading...
