documents can be part of the IPDS data stream. The active transaction setup specifies the
print properties. (
Work with automated workflows
on page 143)
2.
Job planning
One or more jobs are part of a data stream submitted to the printer during a connection
session. When the data stream includes job separators, the printer can distinguish the
separate jobs. In the job monitor of PRISMAproduction you can manage the jobs and define
the job order. (
Monitor or stop transaction print jobs
on page 111) It is not possible to change
the job order or edit transaction print jobs from the control panel. However, if required, you
can stop the printing of the data stream from the control panel.
3.
Print production
The operator keeps the printer running. Correct media are loaded in the paper trays, finished
output and waste are removed in time and there are sufficient supplies of consumables in the
printer. In transaction printing mode, you cannot remove individual jobs. Only the entire data
stream can be aborted from the control panel. The printer constantly sends information about
the printer status and the job progress to PRISMAproduction.
Job workflow in transaction printing mode
Chapter 7 - Transaction printing
107
To Next Page
Loading...
Need help?
General