Oce VarioPrint i Series - Read Tolerance Levels for Color Validation Tests

Read tolerance levels for color validation tests
Evaluation tests can have different quality levels based on different tolerance levels for the same
metric. ( Tolerance levels on page 249)
You cannot change the metrics and tolerance levels for the pre-defined FOGRA and IDEAlliance
color validation tests. The profile accuracy test also has fixed tolerance levels that are not
editable.
1. Open the Settings Editor and go to: [Color]→[Color validation & verification].
[324] [Color validation & verification] tab
2. Select the test.
[325] [Color validation tests] menu
3. Click [Edit].
4. Read the metrics and tolerance levels.
[326] Edit a color validation test
Read tolerance levels for color validation tests
258
Chapter 9 - Print what you expect