Load media into the paper module
Media must be loaded in optimal condition and according to load instructions.
A job also needs media to print nozzle failure detection sheets. These media can be job media, or
alternative media if the job media are not appropriate for nozzle failure detection sheets. These
alternative media are loaded in the paper tray configured for that purpose. (
Define usage of
quality control sheets
on page 243)
[106] Location of the paper module (front view)
NOTE
•
You can leave the media in the paper trays when the printer is in sleep mode. (
Put printer in
sleep mode
on page 324)
• Rewrap all loaded media in the original package or other moisture proof material before the
printer goes in shutdown mode. (
Put printer in sleep mode
on page 324)
Before you begin
• Carefully unpack and check one ream of media or a stack of approximately 500 sheets (80 g/
m² / 20 lb bond). (
Unpack the media
on page 92)
• Load media as soon as possible after unpacking.
• When you load media with a small length (178 mm - 203 mm / 7.01" - 7.99") the paper tray
needs a guidance tool.
[107] Guidance tool
Load media into the paper module
94
Chapter 6 - Job media handling
To Next Page
Loading...
