Oce VarioPrint i Series - Clean the surface of the print belt

Clean the surface of the print belt
When the surface of the print belt is dirty, you see a message on the control panel that you must
clean the print belt surface.
[456] Location of the print belt
Before you begin
• You need to have the rights to access the maintenance tasks and the configuration settings.
• You need cleaning cloths (Alphawipe pads Texwipe TX1004).
• You need a bottle with cleaning process maintenance liquid (PML).
• You need a large sheet of paper.
NOTE
• In order to keep your hands clean, it is advised to use nitrile gloves when you work with ink,
ColorGrip, or PML. For details see the related material safety data sheets. ( VarioPrint i-series
consumables on page 332)
• When you spill any liquid, wipe up the drops with disposable towels and transfer the used
towels to a sealable container appropriate for disposal.
Procedure
Action
1 1. Touch [System]→[Maintenance]→[Unlock print
module].
2 Open the lower and the upper front doors of the print module.
4
Clean the surface of the print belt
Chapter 13 - Maintain the printer
393