Action
8 Close the upper and lower doors of the print module. The print belt starts to run for ap-
proximately 10 minutes.
9 When the control panel indicates that the print belt has stopped, open the lower and upper
front doors of the print module.
10 Turn the two bolts in a counter-clockwise direction to unlock the cleaning plate.
11 Remove the cleaning plate and remove the cleaning cloth from the cleaning plate.
12 Repeat step 4 to 11 to clean the print belt again with a new cleaning cloth.
13 Close the upper and lower doors of the print module.
14 Touch [Confirm] on the control panel.
After you finish
Dispose the used cleaning cloths.
Clean the inner side of the print belt
392
Chapter 13 - Maintain the printer
To Next Page
Loading...
