Oce VarioPrint i Series - Clean the Z-sensors in the registration output module without system tray

Clean the Z-sensors in the registration output module without system tray
There are two registration output modules: with or without a system tray. This topic describes the
cleaning of Z-sensors in the registration output module without a system tray. When the
registration output module has a system tray, see
Clean the Z-sensors in the registration output
module with system tray
on page 367.
When the Z-sensors in the registration output module are polluted, an action required window
appears on the control panel.
[447] Location of the registration output module without system tray
Before you begin
You need cleaning cloths to clean the Z-sensors (Alphawipe pads Texwipe TX1004).
Procedure
Action
1 Open the front door of the registration output module.
2 1. Turn the green knob to unlock the paper
guide.
2. Lift the paper guide until the guide is
locked at the upper side.
4
Clean the Z-sensors in the registration output module without system tray
Chapter 13 - Maintain the printer
365